MANUAL REBAR CUTTER – FMA-800
Rebar cutter is used in construction for the cutting of iron for armatures. Made of very high quality steel with blades set so that they can be reversed which significantly extends the life of the cutter. It is intended for cutting soft rebar of up to ø10 in diameter, and hard rebar of up to ø8 in diameter.
- Length: 900 mm
- Weight: 5.3 kg
- Code number: 1800800
- Small hand tools
- Manual cable and iron cutters
- Manual cable crimpers
- Hydraulic tools for crimping, cutting and punching
-
- DIES FOR: HYDRAULIC CRIMPER FS – 240
- HYDRAULIC CABLE CUTTER
- HYDRAULIC CABLE CUTTER FHM-50
- HYDRAULIC CUTTER FHMC
- MANUAL HYDRAULIC CABLE CUTTER
- MANUAL HYDRAULIC CRIMPER – FTP-300
- MANUAL HYDRAULIC CRIMPER – FRHP-300
- DIES FOR CRIMPER FP – 185
- HYDRAULIC CRIMPER – FF-400
- HYDRAULIC HEAD FOR CRIMPING – FCO-630
- DIES FOR CRIMPERS: FRP-300, FHP-300 FRHP-300, FAP 62
- HYDRAULIC RAIL CUTTER – FHAS-150
- BOLT CUTTER
- Sheet metal punching tools
- Hydraulic pumps
- ACCU TOOLS
- Rollers for laying cables
- Others
-
- HYDRAULIC PRESS – FPS-200
- HYDRAULIC DRILL PRESS FPB-20
- COME-ALONG FOR PULLING AERIAL CABLES 7-15
- PULLEY GEAR WITH WIRE ROPE
- AUTOMATIC GRIPPER 6-14
- AUTOMATIC GRIPPER FOR Al-Fe CABLES 8-24mm
- ELECTRICAL HOIST – WINCH
- DEVICE FOR TIGHTENING CABLES AND HOISTING LOADS
- DEVICE FOR TIGHTENING AND HOISTING LOADS – to 250 kg
- HYDRAULIC HOLE CUTTER – FHPP-60
- MANUAL HYDRAULIC HOLE CUTTER – FRHPP-60
