FLUORESCENT FIXTURES WITH AND WITHOUT SHADES

We make open type fluorescent armatures in three standard dimensions: 20W-618 mm, 40W- 1228 mm, 65W-1528 mm.
We make all three kinds for one, two or three fluorescent tubes with or without the corresponding reflector. The lamp housing is made of pickled, profiled sheet metal with baked on white enamel, completely wired in accord with the appropriate JUS and IEC standards. The lights are made with IP 20 protection and enable quick and easy installation.
They are designed for general use areas: hospitals, hallways, passages, warehouses and all other locations where lights are not exposed to great exposure to dust and damp.
Fluorescent lights can be also installed in a linear system which enables quick mounting and is universally accepted. The linear system consists of an upper part (housing of a specified length) and a lower part (tube housing of a specified electrical power). Advantages are: Quick installation, long lasting and simple maintenance. The linear system is made with IP 20 protection and is recommended for use in factories, halls, warehouses and areas where lights are not exposed to great exposure to dust and liquids. If the area is higher than 5 m we recommend using reflectors that direct the light beam from above.