FUSE RAILS

Used for protection of electrical grid from short-circuiting and overloading. Intended for installation on collectors. Easily installed, take up little free space on the installation board. Housing is made of self-extinguishable polyester reinforced with fiberglass.

HANDLE FOR KNIFE-BLADE FUSES

Used for placing and removing knife-blade fuses NV-00 to NV-03. The handle is made of insulated thermoplastic and can be used without protective gloves.

PLUG FOR ELECTRICAL APPARATUS

Plugs

PLUGS 63A

CONNECTION FITTINGS FOR INDUSTRIAL PURPOSES

Connection fitting are installation materials which are used for connection mobile and transportable users of electrical energy. Construction of the connection fittings allow for the connecting and disconnecting of permanently laid and mobile lines, as well as the switching on and off electricity, without the help of any tools or assistance.

Connections are designated by:

• Electricity, by amperes (A)
• Intensity, by voltage (V)
• Designation for type of electricity (direct and altering current)
• Frequency, by (HZ)
• Designated type
• Manufacturers label
• Level of mechanical protection IP44 and IP67
• Position of protected contact designated

All electrical parts under voltage are totally protected and accessible if the fittings are mounted and used correctly. It is impossible to make a joint between the contactof the plug and the contact of the socket whilst any of the plug contacts are accessible. When unplugging the plug out of the socket the sequence is reversed.

Shown on the picture is the use of the connection fitting:

• Network joints allow for connection of a flexible cable with permanently layed lines. It consists of two parts:
• Socket (1) the part meat for connecting with the permanently layed line.
• Plug (2) represents the part which is used for connecting up to a flexible cable which is connected to a power consumer.
• Line joint – enables joining of two flexible cables. It consists of two parts:
• Plug (3) the part used for connecting onto a flexible cable which is connected to the electric network
• Plug (2)
• Electrical apparatus joint.
• enables connecting of flexible cable with an electrical apparatus. It consists of two parts:
• Plug (3)
• Socket for electrical apparatus (4), which represents the part used for mounting onto the electrical apparatus.

Standards:

International committee CEE has issued a publication as a suggestion for production of jointing fittings for industrial use. International electrical committee has introduced publication 17 worldwide by issuing publication 309 and 309a. According to the publication JUS N.E3 605 bas been created and is valid for connection fittings for industrial use.

POLYETHYLENE TUBING FOR ELECTRICAL INSTALLATION IN CONCRETE

This tubing is laid in concrete structures as well as for lying of EL and TT installations in building slabs before pouring concrete. They are made of self-extinguishing polyethylene in accordance with European standards. It can be easily bent to all angles and all types of wires/cables

can be run through it. Every type of conductor-cable can be easily pushed through them. They are highly resistant to all pressures, also to the spilling of the concrete and all other possible damages. They have shown in practice to be highly reliable and efficient.

IN-WALL JUNCTION BOX FOR PLASTER – ROUND

These boxes are used in installations as junction boxes for connectors.

• Dimensions: 80×45 mm
• Package: 100 pcs
• Weight: 18,2 kg/100pcs

IN-WALL JUNCTION BOX – ROUND

These boxes are used in installations as junction boxes for connectors.

• Dimensions: ø 80×40 mm
• Package: 100 pcs
• Weight: 1,2 kg/100pcs
• Code number: 5116040

IN-WALL JUNCTION BOX – SQUARE

Square in-wall junction boxes are made of self-extinguishing PVC and have eight “soft openings” for cables on the sides and three on the bottom. The cover is easily attached with two screws even when the box is full and installed deep inside the wall.

• Dimensions: 100x100x40 mm
• Package: 100 pcs
• Weight: 18,2 kg/100pcs